Entering ClimbMax Test Mode
access Test Mode:
and hold ENTER key while turning on the ClimbMax.
displays light up as long as you hold
down the key.
you release the key, the readouts show the version of the microprocessor
software and the state of the slack switch (SLACK or TIGHT).
in Test Mode, these keys have special functions:
odometer and RPM sensor data. Also begins and ends a simple test of
the Smart Link electronics.
the belt tensioning motor as long as you hold it down, loosening the
belt. Do NOT hold the ARROW UP to loosen the belt for too long, or
you may tangle or unsnap the belt.
the belt tensioning motor as long as you hold it down, tightening
up each display grouping in turn to locate shorted display drive lines.
up each display segment to locate segments that are shorted together.
the version readout if the odometer or display test pattern is displayed;
otherwise it exits Test Mode and displays the TECTRIX ClimbMax sign-on.
SLOW DOWN or CONTROL LOST
Check Friction Belt
* Check Electrical Cables
* Test Motor
Test Slack Switch
* Test Motor
* Test Slack Switch
contents of the permanent memory have been lost. When Odometer and
Use Count and Club program is cleared, program count defaults to 20
minutes. If problem persists a new display board is needed.
numeral appears in the interval display
electrical supply. Could be caused by turning on/off too quickly,
intermittent power supply, or bad tension motor. Try testing with
a different tension motor.